5
REAR PANEL FEATURES AND FUNCTIONS
MAINS INPUT
SERIAL:
117 V
SPKR OUT
LIFT
GROUND
POWER STATION MODEL PS-100
STEVEN FRYETTE DESIGN, INC.
AMP IN
IMPEDANCE
SELECT
LINE OUT
BALANCED
SPEAKER
2/4
8
16
2/4
8
16
200W
MAX
FT SW
AMPLIFIER
FX SEND
LINE IN
FX RETN
FX
LEVEL
LINE OUT
FUSE
MAIN
T4A
50/60 HZ
300 WATTS
AVIS: RISQUES DE CHOC ELECTRIQUE, NE PAS OUVRIR:
WARNING: HAZARDOUS VOLTAGE INSIDE. REFER
SERVICING TO QUALIFIED SERVICE PERSONNEL:
CAUTION: DO NOT EXPOSE THIS
EQUIPMENT TO RAIN OR MOISTURE:
CAUTION REPLACE ONLY
WITH SAME TYPE FUSE
UTILISER UN FUSIBLE DE
ECHANGE DE MEME TYPE
REFER SERVICING TO
QUALIFIED SERVICE PERSONNEL
NO USER SERVICABLE PARTS INSIDE
LINE
LEVEL
HI
LO
1
5
9
8
12
10
11
14
15
2
6
7
4
13
3
1. L
out, effects processor, pedal preamp or iPhone. Virtually any device that you want to amplify to
listening level through a speaker cabinet can be connected here.
2. L
Power Station Amp In jack and makes it available to drive any external device, such as a mixer,
speaker output plugged into the
Use this feature to send your onstage sound to an external processor and then to FOH, an onstage
powered monitor or a “wet” only amp/effect/speaker system.
3. LINE LEVEL – Simultaneously controls the output level of the unbalanced 1/4“ line out and the
balanced XLR out.
4. L
connected to Amp In.
5. FX SEND – Low impedance effects send jack for use with external effects processor. This connec-
tion is post AMP IN and LINE IN, so any effect connected here will be inserted between your load
remotely engaged or bypassed with a footswitch or remote switching device (see #12 on page 6).
6. FX RETURN – High impedance effects return jack for use with external effects processor. As with
the FX SEND, this connection is post AMP IN and LINE IN, so any effect connected here will be
7. FX LEVEL – This sets the signal level inside the loop. Use the HI position for line level (+4 to 0dB)
devices. Use the LO position for guitar level devices (-10 to -20dB) such as pedal delays, etc. In LO
mode you can even plug your guitar, bass, acoustic instrument pickup or keyboard directly in here
8. A
-
Amp In (Max Continuous):
200W @ 2, 4 & 16 Ohms.
150W @ 8 Ohms
NOTE: Set this impedance to match both the speaker and the load
Most cabs have a
impedance and you usually have a choice of impedance on your
Therefore it is
best to choose the
impedance that will match your speaker cab. This will assure that
your
and speaker are matched correctly when the Power Station is bypassed.
9. AMPLIFIER IMPEDANCE – Sets the impedance of the internal reactive load for optimum perfor-
10. SPEAKER OUT – Connect this output jack to any speaker cabinet or combination of cabinets that
total 2/4, 8 or 16 ohms impedance. For example, when using a 16 ohm cabinet (typically a 4x12
cabinet), you will set the switch to 16 ohms. To connect multiple cabinets, simply use an unshielded
mono Y adapter or splitter cable.
signal processor.
