1-4
1.3 Install Grill Clip
The grill clip is shipped in the accessory package and is
designed to hold the 1/3-size grill tray. It attaches to the
grill to make transfer from the grill to the UHC faster and
safer.
•
Position the front of the grill clip under the lip
of the grill.
•
Lower the back of the clip until the grooves rest
over the grill bar. The grill clip should firmly
seat on the front of the grill. If the clip doesn’t
fit snuggly, simply loosen the four nuts under
the clip and slide it in or out as needed to tighten
against the bar. Tighten the nuts after the clip is
properly adjusted.
1.4 Installation of 4” Legs
CAUTION
Use caution when handling the cabinet or tilting the unit to/from the floor to install
the legs. Maneuvering the cabinet should be accomplished by at least two people.
A.
Carefully place the Universal Holding Cabinet on its right side (direction is determined with
you facing the front of the unit), exposing the base of the cabinet.
B.
Mount the leg pads to the bottom of the base using the 16-¼
"
-20 x ½
"
long screws and
lockwashers provided.
C.
Screw the leg into the mounted leg pad until fully tight.
D.
Carefully turn the UHC upright until the unit stands on its legs. Perform Step 2,
Power Up.
IF THE UHC IS INSTALLED WITH THE COUNTERTOP OPTION, ENSURE THE
AREA WHERE THE UHC BASE AND COUNTERTOP MEET IS PROPERLY SEALED
WITH A FOOD GRADE TYPE SEALANT.
The grill clip attaches to the grill and holds
grilled product in a UHC tray, making
transfer to the holding cabinet easier.
Summary of Contents for Universal Holding Cabinet
Page 46: ...17 1 17 Wiring Diagram UHC...
