1. Plug the compatible SFP/SFP+ optical module into the SFP/SFP+ port.
2. Connect one end of a fiber optic cable to the optical module. Then connect the other end of the
cable to another fiber device.
1. Insert the RJ45 connector of the console cable into the console port of the switch.
2. Connect the DB9 female connector of the console cable to the serial port of the computer.
Connecting the CONSOLE Port
WARNING:
Laser beams will cause eye damage. Do not look into bores of optical modules or
fiber optical cables without eye protection.
Configuring the Switch
Configuring the Switch via the Web-based Interface
Step 1: Connect the computer to the Management port of the switch using the network cable.
Step 2: Set the IP address of the computer to
192.168.1.x.
(“x” is any number from 2 to 254.)
EN
9
Left LED: Link/Act Mode Right LED: PoE Mode
SYS
PWR
PoE
CONSOLE
S3200-8M4GS-U
PoE+
1
2
3
4
1
2
3
4
