13
The currently selected aircraft is displayed on the top of the window
(settings, except communication parameters, will be applied to current
aircraft only)
Check "Enable Stick Shaker" if you wish to activate the Stick Shaker in
current aircraft
Select USB or LAN connection, accordingly to the cable actually used to
connect the CCU. Enter the COM number you annotated before (for USB
connection) or the IP address and Port (for LAN connection).
Stick Shaker
application must be restarted when communication parameters are
changed.
Set how the Stick Shaker should be activated. For most situations and add-
on aircraft, FSUIPC default offset of 036C is fine and doesn't need to be
changed. If you are using a glass cockpit software or an add-on aircraft that
use a custom offset, just select the relevant option and set such offset and
bit (please refer to the documentation shipped with the add-on to know
how the exact offset and bit)
Click ACTIVATE NOW to test the stick shaker and DEACTIVATE to stop it.
If communication parameters were changed, you must restart the Stick
Shaker driver before doing any test
Click OK to save the parameters for current aircraft or Cancel to quit without
saving
Test if the Stick Shaker is working as expected. Fly your plane at a safe
altitude, then enter in a stall.
If everything is working fine, the Stick Shaker will start to vibrate as soon as
the STALL warning is displayed in the cockpit, and will stop as soon as the
normal flight conditions are resumed.
If using mutliple aircraft, repeat the above steps to check/set if the
parameters apply to every aircraft.
Summary of Contents for 116526
Page 2: ......