TROUBLESHOOTING
OPERA
TION
ASSEMBL
Y
/
INST
ALLA
TION
SAFETY
/
SPECIFICA
TIONS
GETTING ST
ARTED
15
MAINTENANCE
/
REP
AIR
MAINTENANCE AND INSPECTION INSTRUCTIONS (CONTINUED)
Components
Turn off all power and clean the cylinder head, motor, fan blades, air lines, aftercooler and tank on a monthly
basis.
Belts
Lock out and tag the power then release all pressure from the tank to prevent
unexpected movement of the unit.
Check belt tension every 3 months. Adjust belt tension to allow 3/8 inch to 1/2 inch deflection with normal thumb
pressure. Also, align belts using a straight edge against the face of the flywheel and touching the rim on both
sides of the face. The belts should be parallel to this straight edge (see Figure 10). Dimension A should be the
same as B and C to ensure proper alignment of the belts.
Slots in the bed-plate allow for sliding the motor back and forth to adjust belt tension.
Storage
If compressor is to be stored for a short period of time, make sure that it is stored in a normal position and in a
cool protected area.
A
B
C
Figure 10 - Top View
Air Compressor
Motor
Flywheel
Straight Edge
Motor Drive
Pulley
Setscrew
Maintenance Schedule
OPERATION
DAILY
MONTHLY
3 MONTHS
Check Safety Valve
●
Drain Tank (see Figure 5)
●
Check Oil Level
●
Clean or Change Air Filter
●
Check Intercooler
●
Clean Unit Components
●
Check Belt Tightness
●
Change Oil (see Figure 4)
●
