25
When supporting models with long overhangs, add supports no further than 3mm apart. This
can be achieved by placing models so that each support’s base touches the surrounding bases.
Some models may be printed with further spacings or fewer supports, but each model will vary.
Select the “Highlight Unsupported Features” to refresh the view. If there are no more red areas
and all yellow areas look supported, continue to print.
Please double check the list below before you proceed to print.
● Are all tapes and films removed from all the printer parts?
● Is the build head level?
● Is the SuperVAT™ and the build head securely installed?
● Is the resin filled below the recommended maximum fill line?
● Is the printer well connected to the power outlet?
● Is the printer connected to your computer with the Ethernet cable, USB cable or Wifi?
Summary of Contents for Phoenix Touch
Page 1: ...1 Main Menu ...
Page 8: ...8 Main Menu ...
Page 32: ...32 Main Menu ...
Page 42: ...42 Transport Information Not regulated for transportation Main Menu ...