23
Automatic supports will add a base and will support most of the crucial layers. This function will
avoid placing supports if it believes that it will intersect the model, so always verify manually that
all sections are supported.
Keep in mind that automatic supports create a base and will raise your model above the build
head. After supporting, verify that the model does not exceed the bounds of the printer.
Automatic Support Modification
Automatic supports will usually create yellow
supports. Yellow supports are recommended
and not always necessary. They could be
left in place or removed.
Model rotated to exaggerate the generation of yellow supports
Left clicking supports will select them. Selected
supports are shown in red. You may select
multiple supports at a time.
● Press the delete key to manually delete
the selected support.
● Leftclick and drag a support to relocate
it to another position.
Summary of Contents for Phoenix Touch
Page 1: ...1 Main Menu ...
Page 8: ...8 Main Menu ...
Page 32: ...32 Main Menu ...
Page 42: ...42 Transport Information Not regulated for transportation Main Menu ...