Quick installation Guide ATLAS 64
We reserve the right to make technical changes without prior notice
.
The manufacturer accepts no liability arising from printing errors.
- 9 -
ATLAS 64 Version en_1.1 (Fte maximal)
Extended
: Mark the checkbox
+1V
to increase the supply voltage 1 volt. Use this option when
the input voltage in the remote device is low for example for a high value of electrical resistance
in long cables.
Tone
: Select between OFF and 22 KHz.
DiSEqC
: Choose between A, B, C and D.
Band
: In this option select between Ku (Universal 9750/10600MHz) and C band.
Enable
: If the option is checked the input is enabled.
Press the button
Apply
to update the change in the device.
6.2.2.
Tuner
This section allows change the settings of the 6 tuners of the headend and show information of
the transponder tuned. First step is to choos the Tab of the tuner to change the settings.
Input Selection:
Select in the list the RF between the 4 available inputs.
Frequency (MHz):
Enter the frequency in MHz.
Baud Rate (KBd):
Type the value of the Symbol rate.
Modulation
: Choose in the list between DVB-S and DVB-S2.
Enable
: Check this option to enable the tuner.
Press
Apply
to confirm. After tune the signal of the transponder in the screen appears the
information of the input level, the quality, the input network information and the service list.