Fume hoods
Soldering irons
Specialized tools for wiring and tinning
Hand tools, consumables and workshop equipment
info@ftm-technologies.com
–
+33 (0)1 40 86 00 09
4
- An overshoot heating could happen at first time. The heating switches off when you remove your finger
from the sensitive button.
- During operation, it is better to await a period of 3 seconds between 2 strippings.
- Adjust the length of stripping (if need be) with the celoron stop.
- Adjust the minimum spacing of the electrodes using the 2 nylon screws on both sides of the grip (this in
order not to harm the core of the cable, and avoid the electrodes to touch each other) : PC3NC, PC3/5C and
PC4NC.
- Engage the switch.
- Adjust the heating temperature according to the nature of the cable sheath.
- The stripping of the cable can be carried out, (avoid turning around the cable with the clamp closed). Proceed
in 2 stages : make a first heating and a second one after having made 1/4 of turn.
Turning off
Stop heating, put the switch on position 0 on the control box.
If non used for a significant time, disconnect the mains cord.
Indicative temperature chart
The temperature reached will depend on the type of electrodes used. The chart below is made for new type
EEDT2 electrodes. These values are indicative and it will be necessary to carry out a preliminary test.
Graduation BDT3A Graduation BDT3 TS Stabilized temperature °C
Insulation
10
70
20
130
PE, PVC
1
30
250
Nylon, Kynar
2
40
350
Tefzel, Silicone
4
50
450
PTFE
5
60
520
PTFE
6
70
600
PTFE
8
80
700
Kapton
10
90
780
Kapton
100
880
Kapton
6.
MAINTENANCE
CAUTION : Before any intervention, withdraw the electric cord of the mains supply.
Power unit
: Wipe with a dry rag.
Plier
: Change the electrodes regularly.
Brush with a metal brush the head of the plier (where the electrodes are fixed).
Tightening of electrodes must be done with recommended couple (see typical value).
C
BDT3A
BDT3 TS
