FUBA
2
3 Mounting instructions
CAUTION
To mount the heating blanket do not use any tool, in order to prevent the eventually damage of the heater.
The mounting of the heating blanket on the satellite dish it is possible only
when the dish is separated from the antenna back mount.
Put the reflector dish on a plain surface to make an easier mounting.
To hook the craps to the border of the reflector dish as into fig.1.
Please let the heating blanket extension with connector is exiting for feed
horn usage.
To adjust the holes of the heating blanket with the holes of the reflector
dish to make easy the mounting. Fix the reflector to the antenna back
mount with heating blanket mounted as into fig.2a for models
AHZ780,AHZ850, AHZ780G,AHZ850G,and fig.2b for AHZ110, AHZ110G.
Fig1
Fig2a - AHZ780, AHZ850, AHZ780G, AHZ850G
Fig2b - AHZ110, AHZ110G
Pass the heating blanket extension to the antenna feed horn by using the arm feed structure.
Keep the extension stretched and distributed along the arm feed structure avoiding any overlapping.
To block the heating blanket extension by using some velcro straps.
Fig3a - AHZ780, AHZ850, AHZ780G, AHZ850G
Fig3b - AHZ110, AHZ110G
To connect to the power network by using the connector of the
heating blanket. To connect the cables with respect of polarities. To
connect the green/yellow cable to the ground connector marked by
the symbol
.
CAUTION
The supply cable
must
be FROR type and in any case complying the following standards: CEI EN 60228,
CEI 20-11, CEI EN 50363, CEI 20-22/II, CEI EN 60332-1-2, CEI EN 50267-2-1 IEC 60754-1, CEI 20-34/0-1,
HD 605
