7
FUNCTIONS
At the start
Plug in the power cord onto the proper wall outlet and turn on the power switch of the treadmill. Make sure
the safety switch is on as the treadmill will not start without putting it on. When the power is on, all lights on
the display will be lit instantly.
Calibration Mode
In ready mode, pulling off the safety key, the display shows E0. Pressing and hold MODE key then putting
on the safety key, the unit enters engineering mode.
1. Press Clear/SET key to change the set value (wheel size 46, minimum speed 1KM, maximum speed 16
KM, incline level 12)
2. When finish setting, press Clear/SET key to enter calibration mode then press START key to run speed
and incline calibration. The unit returns to ready mode automatically when calibration ends.
3. Please do not change the engineering mode setting values otherwise the speed or the incline value
alters.
Quick Start Operation
1.Press START / STOP key to wake up the console display (if it is not on). Note: Replacing the safety
switch will also wake up the control console.
2.Press START / STOP key and the treadmill starts at speed 1.0 km/h. Then use speed keys
“↑”
or
“↓”
adjust to the desired speed. You can also use quick speed keys
“
WALK
”
,
“
JOG
”
or
“
RUN
”
for speed adjustment. The speed ranges between 1 km/h and 16 km/h.
3.To let the treadmill slow down, press speed
“↓”
or quick speed keys
“
WALK
”
,
“
JOG
”
or
“
RUN
”
until reaching the desired speed.
4.During the workout, press START / STOP key to pause.
5.During the workout, press CLEAR / SET key once resets all data except speed, then the treadmill enters
manual mode.
6.Pressing START/STOP key ends the workout.Quick-Start Operation.
The Incline feature
·
The incline is adjustable at any time after workout.
·
The range of the incline level is 0 to 12.
·
Press “INCLINE
↑
“ or “INCLINE
↓
” to adjust the incline level of the treadmill. There are three quick
incline keys “3”, “6” or “9” for incline level adjustment.
·
The incline level is displayed on the console.
·
Turing off the console keeps the incline level unchanged.
Heart Rate Control feature
Heart Rate Control window displays your heart beats per minute during your workout.You must use both
stainless steel sensor to display your heart beat. The heart beat signal is displayed on the heart rate window.
Calorie Display
This display shows the cumulated calorie sonsumption anytime during your workout.
Note: This is only a rough guide for comparison among different workouts and cnanot be used for medical
purposes.
