4
STEP 1:
1. Locate the Console Mast (2) and slide on the Console Mast Cover (107). Make
sure the cover is facing the correct direction, as shown below, before sliding onto
mast. Install the wiring harness (80) into the bottom of the mast and out the top. Be
careful when installing the console mast to the mainframe so as not to pinch or cut
the wiring harness, damage to the console may occur.
2. Secure Front Stabilizer (4) and Rear Stabilizer (5) with 4pcs of 3/8" Cap Nuts (98),
4pcs of 3/8" Curved Washers (96) and 4pcs of 3/8" ×
2-3/4"
Carriage Bolts (95) by
using
14&15mm Wrench
(79).
3. Install the console mast on the mainframe using the 6mm Allen Wrench (87) to
tighten 5pcs of 5/16" × 3/4" Socket Head Cap Bolts (32), 4pcs of 5/16" Flat
Washers (33), 5pcs of 5/16" Split Washers (35) and 1pcs of 5/16" Curved Washer
(34). Snap the Console Mast Cover (107) in place on the body of the bike.
Assembly Instructions
