Fuel Fitness Elliptical FE46, Owner'S Manual

FE46  Elliptical

9

assembly. The rod end bearing should be positioned to the inside of the bracket on the Lower
Handle Bars. Install two 5/16" x 32m/m Hex Head Bolts (71) through the left and right Lower
Handle Bar brackets and the rod end. Install two 5/16" x 20 x 1.5T Flat Washers (98) and two
5/16" x 7T Nylon Nuts (105) on the 5/16" x 32m/m Hex Head Bolts (71) and tighten firmly by
using 12m/mWrench (110) and 13/14 m/m Wrench (111).

2.

Install the two Rear Rail Tubes (16) with rear end of the Main Frame (1) and secure with two
3/8  x 2-1/4  Button Head Socket Screws (76), two 3/8  x 19 x 1.5T Flat Washers (94) and two
3/8  x 7T Nylon Nuts (89) by using 13/14 mm Wrench (111) and M5 Allen Wrench (108).

3.  Install the Rail Stabilizer (15) between the rear end of the Rail Tubes (16) and secure with

four 3/8  x 2-1/4  Button Head Socket Screws (76) and 3/8  x 23 x 2T Curved Washers (114)
by using the M5 Allen Wrench (108).

STEP 4: Beauty covers assembly

1.  Install the Connecting Arm Covers (59 & 60) over the connection of the rod end and

Lower Handle Bars (4 & 5) with four M5 x 15m/m Phillips Head Screws (79) and two
3.5x12m/m Self Tapping Screws (84) by using the Phillips Head Screw Driver (108).

2.  Install the two Wheel Covers (52) on the pedal arms above the Wheels with the four

M5x15m/m Phillips Head Screws (79).

3.  Install the Front Handle Bar Covers (54 & 56) and Rear Handle Bar Covers (55 & 57)

over the Handle Bars axle connections with the six 3.5x12m/m Self Tapping Screws
(84).

4.  Install the two Middle Stabilizer Covers (61) on the joint of the Rail Tubes (16) and the

Stabilizer. Secure the covers with two M5 x 15mm Phillips Head Screws (79).

5.

Install the Rear Stabilizer Covers (62 & 63) on the rear end of the Rail Tubes (16) and

secure them with two M5 x 15mm Phillips Head Screws (79).

POWER CONNECTOR LOCATED ON
FRONT, LEFT HAND SIDE OF UNIT.