8
FE44
ELLIPTICAL
#147. Ø8.5 × 26 × 2.0T
Flat Washer (2 pcs)
#151. 5/16” x 15mm
Button Head Socket Bolt
(2 pcs)
2
Hardware Step 2
1. Put Lower Handle Bars (L) and (R), (4) and (5), at each side of Console Mast
shaft and secure with two Button Head Socket Bolts (151) and two Flat Wash-
ers (147) by using Combination M5 Allen Wrench & Phillips Head Screw Driver
(108).
2. Release and take apart Pedal Axle (17) on left Pedal Arm (2) and install left
Connecting Arm (7) onto left Pedal Arm. Tighten the screw together with
the previously released Pedal Axle with 12mm and 14mm open end wrench.
Repeat the same procedure again for the right Connecting Arm (8) and Pedal
Arm (3).
3. Release rod end shafts (16) which are on left and right connecting arms(7.8).
Connect the left and right connecting arm (7.8) with left and right lower
handle bar(4.5) and secure with rod end shafts (16) and the screw by using
the Wrench (160m/m)(111).
SWING ARMS
