Fuel Fitness FE44, Owner'S Manual

FE

44

 ELLIPTICAL

19

1.  Wipe down all areas in the sweat path with a damp cloth after each workout.

2.  If a squeak, thump, clicking or rough feeling develops, the main cause is most likely one of two reasons:

i. 

installed during assembly need to be tightened as much as possible. It may be  

-

ity of calls to the service department for noise issues can be traced to loose hardware or the rear rails being 

dirty.

ii.  Dirt build-up on the rear rails and polyurethane wheels are also a source of noise. Noise from build-up on the 

rails can cause a thumping sound that you would swear is coming from inside the main body of the machine 

cloth and rubbing alcohol. Stubborn build-up can be removed with your  

thumbnail or a non-metallic scraper, like the back edge of a plastic knife. After cleaning, apply a  

3.  If squeaks or other noises persist, check that the unit is properly leveled before calling the service department.

The console has built in maintenance/diagnostic software. The software will allow you to make changes to the console 

waking your family during your early morning workouts). To enter the Engineering Mode press and hold down the 

Start

, 

Stop

 and 

Enter

“Engineering Mode”. Press the 

Enter

 key to access the menu below. Press the 

Level

Up/Down

 keys to navigate the 

menu. 
A. Key Test - Will allow you to test all the keys to make sure they are functioning
B. Display Test - Automatically tests all LCD’s
C. Functions - Press Enter to access settings, use Level UP/DOWN keys to scroll

i.  ODO Reset - Resets the odometer

ii.  Units - Choose from English(Imperial) or Metric display readings

iii. 

iv.  Motor Test - Continually runs the tensioning gear motor

v.  Manual - Allows stepping of the gear motor

vi. 

vii. 

D. Security - Allows you to lock the keypad so no unauthorized use of the machine is allowed. When the child lock 

is enabled, the console will not allow the keypad to operate unless you press and hold the Start and Enter buttons 

for 3 seconds to unlock the console

E. Factory Set

F. Exit - Select to exit Maintenance Menu

General Maintenance

ENGINEERING MODE

Your new elliptical is engineered and manufactured to the strictest industry standards and tolerances. All elliptical 

trainers, no matter who the manufacturer, have a multitude of moving linkages and parts. Be aware that even with the 

tightest mechanical tolerances there still could be a slight amount of play between some parts. This inherent play can 

result in slight noises during use such as clicks and small thumps. Please expect that the  

elliptical will not be completely silent.

ELLIPTICAL NOISES