7
STEP 4:
1. Locate the Pedal Axle Spacer (25) and Right side Pedal Arm Assembly (2) and
install onto the pedal axle at the large rotating wheel at the rear of the elliptical. Use
the M5 Allen Wrench (68) to tighten the 5/16” Button Head Socket Bolt (43) and
5/16” Flat Washer (44).
2. Locate the 1/2" ×
70mm
Carriage Bolt (29) and slide through the bracket at the front
of the Pedal Arm Assembly (2) and Lower swing arm (6). Use the19m/m Wrench (69)
to tighten the 1/2" Nyloc Nut (30) to the carriage bolt (29).
3. Install Pedal Arm Covers (85, 86) on the Pedal Arm Assembly (2) and use Phillips
Head Screw Driver (68) to tighten the 3.5 × 12L Sheet Metal Screw (52).
4. Repeat steps 1-3 above for the left side pedal arm assembly.
