3
STEP 1:
1.
Locate the Console Mast (2) and slide on Console Mast Cover (48). Make sure
the cover is facing the correct direction, as shown below, before sliding onto mast.
Install the wiring harness (37) into the bottom of the mast and out the top. Be
careful when installing the console mast to the mainframe so as not to pinch or cut
the wiring harness; damage to the console may occur.
2.
Install the console mast on the mainframe using the M5 Allen Wrench (33) to
tighten 5pcs of 5/16” Button Head Socket Bolts (26), 4pcs of 5/16” Flat Washers
(27) and 1pc of 5/16" Curved Washer (28). Snap the Console Mast Cover (48) in
place on the body of the Bike.
3.
Secure Front Stabilizer (4) and Rear Stabilizer (5) with 4pcs of 5/16” × 3/4” Button
Head Socket Bolts (26), 4pcs of 5/16" Split Washers (29) and 4 pcs of 5/16” Flat
Washers (27) by using Combination M5 Allen Wrench & Phillips Head Screw
Driver (33).
Assembly Instructions
