WWW.FUHR.DE
6
SmartTouch
2.0
3.4 Installation of the SmartTouch door handle
3.4.1
On Aluminium, wood or PVC profiles
200
/
800
/
1400
Make a cross drill hole for the
Smart radio module on the
bottom screw hole.
1.1
Additional step at timber profiles:
Drill hole for fixing screw
Avoid damage of lockcases and cables
at all costs!
Plug all cables together.
For the correct connectionof the
smart radio module see chapter
3.2
.
4.
4.
Connecting
cable
Smart radio
module cablel
Cable to motor
1.
3.
2.
SW13
Ø 8,5 mm
Ø 8,5 mm
Screw drill holes with 8,5 mm Ø on desired
position.
We recommend choosing the drill hole
positions so that the centre of the door handle
is at 1,300 mm. The position of the lockcases
or a sufficient thickness of the profile must be
considered, see picture I and II in chapter
3.1.1
.
On timber profiles there has to be a cross drill addi-
tionally. See step
1.1
in the picture below.
Pre-cut the thread with fastening screw
A,
please
grease the screw beforehand (for PVC profiles with
steel reinforcement please pre-cut with an M10
tap), unscrew it and screw in fixing screw
B
.
Screw and tighten fixing screw
A
.
1.
2.
3.
1.1
