Thank you for selecting the Fuji Programmable Operation Display, POD UG520/420/
320/221/220 Series (called as the UG20 or POD, hereafter).
For proper set-up, you are requested to read through this booklet to understand more
about the product.
For more information about UG20 series, refer to the Reference Manual.
For further details about the PLC, see the manual attached to each PLC.
[Reference]
In addition to this manual, the following manuals on the UG20 Series are available.
Please ask your nearest dealer for the appropriate manuals and read them as required.
UG Series
Preface
Name
Manual No.
Contents
UG Series Manual
FEH375
Describes how to operate screen editor
<Operation>
(UG00S-CW) for the UG Series.
UG Series Manual
FEH376
Describes the functions of the UG
<Function>
Series.
UG Series Manual
Describes the procedures for communication
<CC-Link Communications>
FEH355
with PLCs using the optional CC-Link interface.
UG Series Manual
Describes the procedures for communication
<T-Link Communications>
FEH356
with PLCs using the optional T-Link interface.
UG Series Manual
Describes the procedures for communication
<SX-BUS Communications>
FEH357
with PLCs using the optional SX-Bus interface.
UG Series Manual
Describes the procedures forcommunication
<OPCN-1 Communications>
FEH358
with PLCs using the optional OPCN-1 interface.
UG Series Manual <Variable
Describes the variable name cooperation function
Name Cooperation Function>
FEH363
to be used between the UG editor and D300win.
UG Series Manual
Describes the procedures for communicating
<Ethernet Communications>
FEH366
via the optional ETHERNET interface.
UG Series Manual
Describes the procedures for communicating
<FL-Net Communications>
FEH367
via the optional FL-Net interface.
UG Series Manual
Describes the procedures for communicating
<PROFIBUS Communications>
FEH368
via the optional PROFIBUS interface.
UG Series Manual <Ladder
The Functions and instructions of the Ladder
Monitor Specifications>
FEH379
Monitor are explained.
[Notes]
(1)This manual may not, in whole or in part, be printed or reproduced without the prior written consent
of Fuji Electric Co., Ltd.
(2)Information in this manual is subject to change without prior notice.
(3)Windows and Excel are registered trademarks of Microsoft Corporation in the United States and other
countries.
(4)All other company names or product names are trademarks or registered trademarks of their respec-
tive holders.
(5)This manual is intended to give accurate information about POD hardware. If you have any ques-
tions, please contact your local distributor.
Summary of Contents for UG220H Series
Page 270: ...Appendix Ladder Transfer Function...
