1 - 32
Printer Interface (CN2)
13
When a printer is connected to POD via the connector (CN2), it is possible to hard-copy the screen
display of POD, the data sheet, or the sampling data.
To connect a printer to POD, use the parallel interface cable of 36 pins which is optional equipment made
by Fuji Electric. Co., Ltd. (UG00C-C).
When using CBM292/293 printer, our printer cable be (UG00C-A) is available.
Compatible Printer Control Code System and Printer Models
NEC
PC-PR201 series
EPSON
Compatibles with ESC/P24-84 or later
HP(HEWLETT PACKARD) PCL Level 3
CBM292/293
Line thermal panel printer made by CBM Corporation.
(The screen copy cannot be printed out.)
CN2
MJ1
MJ2
CN
1
100-
240VAC
L
N
NC
to Printer
Half pitch 36 pins
Centronics
13 Printer Interface (CN2)
24V D
C
(
+
)
(
-
)
TB1
CN2
UG220
to Printer
Note of Usage of SRAM Memory Card (UG00K-Sx) or SRAM Cassette (UG00P-SR•UG221P-SR);
In case of connecting a printer to UGx20 series with a “UG00K-xx(Memory Card:SRAM)” or “UG00P-
SR•UG221P-SR (SRAM cassette)” at all times, be sure to turn off a printer at the same time when turning
off UGx20. If a printer is not turned off when UGx20 is turned off, the voltage will circulate from the power
supply line of a printer to make the power consumption of SRAM cassette’s backup battery increase, and
finally, the backup battery will consume drastically within a few months.
Summary of Contents for UG220H Series
Page 270: ...Appendix Ladder Transfer Function...
