2 - 143
TOYO DENKI PLC
(uGPC sx series)
Available PLC
*
Only one unit of POD can be connected to one link unit, except for “Multi-link 2” connection.
Communication Setting
The recommended communication parameter setting of both PLC and POD is as follows:
*
No function block (FB) settings are required on the PLC.
Available Memory
Set the memory to the extent of the memory range of each PLC model.
Use TYPE number to assign indirect memory for macro programs.
To set an indirect memory using a macro, specify the CPU No. using the extended code.
Indirect memory setting by macro is not available for input (I) or output (Q) memory.
Standard Memory
TYPE
Remarks
I
(input memory)
-
O
(output memory)
-
M
(standard memory)
2
RM (retain memory)
4
SM
(system memory)
8
PLC
NP1L-RS2
NP1L-RS4
NP1L-RS1
RS-232C [Wiring Diagram 1]
RS-485 [Wiring Diagram 2]
RS-232C [Wiring Diagram 1]
RS-485 [Wiring Diagram 2]
Select PLC Type
uGPCsx
Series
UG00C-S
uGPCsx CPU
uGPCsx Series
Wiring Diagram
Link Unit
Transmission
Control Mode
RS-232C
RS-422
Baud Rate
Parity
Data Length
Stop Bit
Item
Setting of PLC
RS-232C
RS-422
Mode 2
Mode 1
Comm. Parameter of POD
1 (fixed)
8 (fixed)
Even (fixed)
38400bps (fixed)
57
57 TOYO DENKI PLC
Summary of Contents for UG220H Series
Page 270: ...Appendix Ladder Transfer Function...
