172
Using the Operator Panel Menus and Keypad
• mm / inch
Purpose:
To specify the measurement unit displayed after the numeric value on the operator panel.
Values:
• Low Toner Alert Msg
Purpose:
To specify whether to show the alert message when the toner is low.
Values:
• Show Paper Size/Type Error
Purpose:
Specifies whether to use paper of a different size when the paper that is loaded in the printer does not match the
paper size settings for the current job.
Values:
• Power On Wizard
Purpose:
To perform initial settings for the printer.
See also:
•
"Setting Initial Settings on the Operator Panel" on page 25
Values:
Out of Paper
Off
Does not emit a tone when the printer runs out of paper.
Min
Emits a tone at the specified volume when the printer runs out of paper.
Middle
*
Max
All Tones
Off
Disables all the alert tones.
Min
Sets the volume of all the alert tones at once.
Middle
*
Max
Millimeters (mm)
*
Specifies the default measurement unit.
Inches (")
Off
Does not show the alert message when the toner is low.
On
*
Shows the alert message when the toner is low.
On
Shows the alert message when the paper size loaded in the printer is different
from the paper size set for the current job.
On(Except A4/Ltr)
*
Shows the alert message except for the time A4 size paper is loaded in the printer
and letter size is set for the current job and for the other way around.
Off
No paper size substitute accepted.
Yes
Performs the initial settings for the printer.
No
*
Does not perform the initial settings for the printer.
