Troubleshooting
200
The Output Is Too Light
NOTE:
•
If the problem continues even though you have taken suggested actions described above, contact the Fuji
Xerox local representative office or an authorised dealer.
Problem
Action
The output is too light.
The toner cartridges may be low or need to be replaced. Confirm the
amount of toner in each toner cartridge.
1
Check the toner level in the
Status
tab in the Status Monitor
window.
2
Replace the toner cartridges as necessary.
Verify that the print media is dry and the correct print media is used.
If not, use the print media recommended for the printer.
See also:
• "Usable Print Media" on page 117
Try changing the
Paper Type
setting in the print driver.
1
On the
Paper / Output
tab in
Printing Preferences
of the print
driver, change the
Paper Type
setting.
Disable
Draft Mode
in the print driver.
1
On the
Advanced Settings
tab in
Printing Preferences
of the
print driver, ensure that the
Draft Mode
check box is not selected.
Summary of Contents for DocuPrint CP205 w
