Safety Notes
11
Do not incline the product at more than 10 degree angle. Otherwise, it may
fall over and cause injuries.
Always lock the wheels of this product after installation. Otherwise, it may fall
over or slide and cause injuries.
To keep this product in a good performance and condition, always use it in
the following environment:
z
Temperature
: 10 - 32
°
C
z
Humidity
: 15 - 85 %
When the product is left in a chilly room and the room is rapidly warmed up by
heater, dew condensation may form inside the product and cause a partial
deletion on printing.
To bundle wires and cables, always use the cable ties and spiral tubes that
Fuji Xerox supplies. Otherwise, it may cause some defects.
Operational Safety
The operator's product maintenance procedures are described in the
customer documentation supplied with this product. Do not carry out any
other maintenance procedures not described in the documentation.
This product features safety design not to allow operators access to hazard
areas. The hazard areas are isolated from operators by covers or protectors
which require a tool to remove. To prevent electric shock and injuries, never
remove those covers and protectors.
To avoid the risk of electric shock and a fire accident, switch off and unplug
the product promptly in the following conditions, then contact your local Fuji
Xerox representative.
z
The product emits smoke or its surface is unusually hot.
z
The product emits unusual noise or odor.
z
The power cord is cracked or worn down.
z
A circuit breaker, fuse or any other safety device is activated.
z
Any liquid is spilled into the product.
z
The product is soaked in water.
z
Any part of the product is damaged.
Do not insert any object into slots or openings of this product.
Do not place any of the followings on the product:
Summary of Contents for DocuScan C1500
Page 34: ......
Page 35: ...3 3 Maintenance This chapter describes how to clean the machine z Cleaning the Machine 34 ...
Page 38: ......
Page 48: ......
