70
Optional Units Manual
Staple Cartridge for Side Stitch
Refer
If the staple cartridge happened to come off the holder, refer to "7.3.3 Re-inserting the Staple Cartridge"
(p.72) for solutions.
1.
Make sure the printer has stopped operations, and
then open the cover of the Finisher.
2.
Pull out "R1".
Note
After removing the staple cartridge, check the inside
of the Finisher for any remaining staples.
3.
Open the unit cover, and remove jammed staples as
shown in the figure.
4.
Insert the unit to its original position.
5.
Close the cover.
If you cannot remove the staples by performing the above procedures, contact your local Fuji Xerox repre-
sentative.
CAUTION
Be careful not to get injured when removing jammed staples.