The local dealer may programming the transceiver with the QT and
DQT, when you choose these channels, you can just hear the same
code in the same channel, any others will not receive.
Display mode
Press the CH2F can switch from frequency mode to channel mode.
Scanning
Channel display mode
Scanning is useful function, it used to monitor the channel’s signal of the
transceiver. When scanning, the transceiver will test the signal to every
channel and stop on the channel which has the signal input.
Note:
the channels which are the delete list will not be scanned.
The transceiver will keep on the transmitting channel till the signal
disappear, the scanning will return in 5 minutes after the signal disappear
except receive the new signal in the delay time.
Note:
Just when your local dealer programming at least 2 channels, it can
use the scanning function. Otherwise must at least 2 channels not
setup for the scan deleted.
About how to use the code squelch or the transmitting scanning,
please ask the local dealer, star scanning please press SCAN.
Scanning start from current channel, the channel number rise, the
screen display “SCAn”. Finish scanning, press the buttons except
MONI, PTT and LAMP.
When scanning stop in one channel, the dot between “CH” and
channel number flicker.
In any time of scanning, if you press PTT button it will stop
scanning, the transceiver return to the latest channel and transmit.
If always receive the signal in the period of scanning, it will return
to the start channel and transmit.
Frequency display mode
Use the scanning function on the frequency display mode, press the
SCAN button, the transceiver will scan for the step frequency from the
current frequency. When the transceiver receiving the signal and stop
