1. Assemble the bowl onto the motor base, the bowl must be aligned to the
same point as the motor base.
2. Assemble the sieve inside the bowl.
3. Put together the squeezer and the strainer into one part.
4. Assemble the squeezer with the strainer inside the bowl. Rotate the
squeezer while pushing down until it falls right into place.
5. Assemble the feeder onto the bowl.
6. Twist the feeder clockwise going to the arrow, and then fix it on the
point. Be sure to align the arrow on the feeder.
7. Place the pulp stopper under the bowl. Please close the lid every time
before use. When cleaning, open it and wash out the trapped food
particles.
1. Prepare the ingredients to be used. Plug in the unit.
2. Press the forward button to operate.
NOTE: Use the reverse button to push the ingredients back up to
dislodge them
3. Insert the ingredients prepared one at a time.
NOTE: The ingredients doesn’t need to be cut into very small pieces.
4. Use the presser to press down the ingredients down to the squeezer.
5. Switch off the unit after the pulp and juice are completely extracted.
INSTALLING THE JUICER
OPERATING THE JUICER
PARTS OF THE JUICER
1. Presser
2. Filling Tube
3. Squeezing Auger
4. Filter
5. Sieve
6. Bowl
7. Motor Base
8. Pulp Deposit
