Preparation Before Use
8
How to replace the Remote Controller Stand.
<In case the Remote Controller Stand, after being installed,
needs to be replaced from left to right side.>
First, take the following procedures:
Remove the pillow and the back pad (see Page 7).
Remove the Remote Controller from its stand.
Then, remove the shoulder unit and the arm unit,
and turn the back-rest forward (see Page 5, 6 and 7).
*
The Remote Controller Stand does not have to be removed from the arm unit.
<In case the Remote Controller Stand is installed at the right side from the first, take
the following procedures starting 1.>
1. Remove the rubber cord grip behind the arm-rest
①
.
2. Remove the Remote Controller cord from its cord grip
②
.
3. Hang the Remote Controller cord on the cord grip at the opposite side
③
.
4. Adjust the position of the rubber cord grip so that the cord may not loosen, and
insert the grip into the hole of the arm-rest
④
.
The cord may snap if it loosens.
5. Raise the back-rest, and install the arm unit equipped with the Remote Controller
Stand at the opposite side (see Page 7).
6. Adjust an angle of the Remote
Controller holder.
7. Install the pillow and the
back pad (see Page 7).
Request
Power switch
Remove the rubber cord
together with its grip.
Caster
Cord
grip
Remote
Controller cord
Rubber cord grip
Hole
Cord grip
Rubber cord grip
Cord grip
[View of the finished work]
Rotate the stand at 180 .
Fixing screw
Tighten
Loosen
