5. Inspection
FinePix S602 ZOOM SERVICE MANUAL
64
5-2.Inspection
5-2-1.External Inspection
Procedure and Checks
1) Check the camera visually for damage to the exterior.
2) Check that there are no problems (eg dust, clouding) with the EVF and
LCD monitors.
5-2-2.Power Supply Switch Check
Procedure and Checks
1) Use the power supply cable jig to supply 4.50V (+/-0.05V) from the DC-IN
jack.
When supplying power from the DC-IN jack, check remotely to ensure
that the voltage does not drop at the DC-IN pin.
2) Set the mode dial to
AUTO
.
3) Set the camera power lever to the Photography mode.
· Check that the indicator lamp is green.
· Check that the lens extends.
· Check that the date setup screen is displayed.
4) Press the BACK button once.
· Check that the date etc is displayed on the LCD monitor for approxi-
mately two seconds.
* Date format differs with region.
J : YYYY.MM.DD
U : MM/DD/YYYY
E/EG : DD.MM.YYYY
5-2-3.Checking Shock Noise in the Movie Mode
Procedure and Checks
1) Apply an appropriate shock to the camera.
* Do not apply a shock directly to the lens or card cover.
· Check for problems with the LCD monitor.
· Check that the camera recovers from sync disturbance.
· Check that the camera power is not OFF.
5-2-4.EVF Check
Procedure and Checks
1) Press the EVF/LCD button.
· Check that the LCD monitor is switched OFF, and that a normal
through image appears on the EVF.
2) Turn the diopter adjustment dial up-down.
· Check that the out-of-focus on the EVF screen changes.
· Turn the zoom between upper and lower limits.
3) After checking the EVF, press the EVF/LCD button again.
· Check that the EVF is switched OFF, and that a normal through image
appears on the LCD monitor again.
