146
Troubleshooting
Intelligent Face
Detection
Cannot set
Intelligent Face
Detection.
The Shooting mode is set to
,
,
.
, ,
, ,
or .
Change the Shooting mode.
49
Macro
Cannot set the
camera to Macro
(close-up) mode.
The Shooting mode is set to
H
,
,
,
.
,
/
, , , , ,
or .
Change the Shooting mode.
49
Flash
Cannot use the
flash.
The shutter button was pressed while the
flash was charging.
Wait until the charging is completed before
pressing the shutter button.
66
The flash is not popped up.
Pop up the flash.
66
The Shooting mode is set to
,
,
, ,
, or
.
Change the Shooting mode.
49
The batteries have run out.
Load new or fully charged batteries.
15, 16
Continuous shooting is selected.
Set continuous shooting to OFF.
68
>
Super macro mode is selected.
Cancel
>
Super macro mode.
65
The flash settings
are restricted and
cannot be
selected.
The Shooting mode is set to anything other
than
H
and
N
.
The flash settings are restricted because
the camera settings are tailored to the
scene being shot. Change the Shooting
mode for a wider range of flash settings.
49, 67
The playback
image is dark
even though the
flash was used.
The subject is too far away.
Move to within the effective flash range
before taking the picture.
66,
152
Your finger was covering the flash.
Hold the camera correctly.
27
Photographed images
The image is
blurred.
The lens is dirty.
Clean the lens.
137
AF frame (lit red) and
{
appeared when
taking pictures.
Check the focus on the subject and take
pictures.
27,
32,
140
appeared when taking pictures.
It may cause camera shake. Hold the
camera steadily.
28,
140
There is speckling
on the image.
The picture was taken with a slow shutter
speed (long exposure) in a high-
temperature environment.
This is a characteristic of CCDs and does
not indicate a camera fault.
–
Matters
Problems
Possible causes
Solutions
Page