128
Power Supply and Battery
Z
Battery Features
• The NP-40 gradually loses its charge even when not
used. Use a NP-40 that has been charged recently (in
the last day or two) to take pictures.
• To maximize the life of the NP-40, turn the camera off
as quickly as possible when it is not being used.
• The number of available frames will be lower in cold
locations or at low temperatures. Take along a spare
fully charged NP-40.
You can also increase the amount of power produced
by putting the NP-40 in your pocket or another warm
place to heat it and then loading it into the camera just
before you take a picture.
If you are using a heating pad, take care not to place the
NP-40 directly against the pad. The camera may not
operate if you use a depleted NP-40 in cold conditions.
Z
Charging the Battery
• You can charge the battery using the camera, cradle,
and the AC power adapter (included).
• The NP-40 can be charged at ambient temperatures
between 0°C and +40°C (+32°F and +104°F). At an
ambient temperature of +23°C (+73°F), it takes
approx. 2 hours to charge a fully depleted NP-40
battery.
• You should charge the NP-40 at an ambient
temperature b10°C and +35°C (+50°F and
+95°F). If you charge the NP-40 at a temperature
outside this range, charging takes longer because the
performance of the NP-40 is impaired.
• You cannot charge the NP-40 at temperatures of 0°C
(+32°F) or below.
• You can also use the optional Battery Charger BC-65S
to charge the NP-40. When charging, use the NP-40
battery adapter supplied with the BC-65S (Refer to the
Owner's Manual for details).
• The NP-40 can be charged using the BC-65S Battery
Charger at ambient temperatures between 0°C and
+40°C (+32°F and +104°F). At an ambient
temperature of +23°C (+73°F), it takes approx. 95
minutes to charge a fully depleted NP-40 battery.
• You should charge the NP-40 at an ambient
temperature b10°C and +35°C (+50°F and
+95°F). If you charge the NP-40 at a temperature
outside this range, charging takes longer because the
performance of the NP-40 is impaired.
• The NP-40 does not need to be fully discharged or
exhausted flat before being charged.
• The NP-40 may feel warm after it has been charged or
immediately after being used. This is perfectly normal.
• Do not recharge a fully charged NP-40.
Notes on the Battery (NP-40)
This camera uses the Rechargeable Lithium-ion Battery
NP-40. Note the points below when using the
rechargeable battery. Take particular care to read the
Safety Notes to make sure that you use the battery
correctly.
*
When shipped, the NP-40 is not fully charged. Always
charge the NP-40 before using it.
• When carrying the NP-40, install it in a digital camera or
keep it in the soft case.
• When storing the NP-40, place it inside the special soft
case provided.
Summary of Contents for FinePix Z3
