4. Adjustment and Inspection
FinePix4800Zoom(U/E/EG) SERVICE GUIDE
22
<Fig.3> Adjustment Items Select Screen
4-3-4.Starting the Adjustment Software
<Step 1>
Double-click on the executable file FFW217.exe to
display the FFW Start-up Screen (Fig.E).
<Step 2>
Select Operation -->Start to run (Fig.1-(1)-->Fig.1-(2)).
<Step 3>
When Operation--->Start is run the start screen is
opened. Set the camera to the jig mode, and press
the Enter key on the PC keyboard.
* Setting the camera in the jig mode
1) Supply 5.0±0.1V from the DC IN terminal (Note 1).
2) Connect the USB cable.
3) Open the card cover.
4) Switch power ON while pressing the DISP but-
ton.
Note 1:
Take the 5.0±0.10V supply from the lithium battery
adjustment jig when adjusting mode dial/battery
voltage. When completing adjustment immediately
after adjustment of mode dial/battery voltage, al-
ways ensure that E: Termination Setting has been
completed before completing adjustment (see the
page on adjustment items for details).
Note 2:
Ignore until an instruction is received when
downloading firmware.
<Step 4>
When the Enter key on the PC is pressed the Adjust-
ment Items Select Screen (Fig.3) is displayed.
Select the item to be adjusted (Fig.3-(1) shows the
camera firmware version to be adjusted).
(1)
<Fig.2> FinePix 4800Zoom PC Adjustment Soft-
ware Start Screen
<Fig.1> FFWJ217.EXE Start-up Screen
(1)
(2)
Adjustment item
Selection
Display LCD adjustment
Press the L key on the PC.
CCD defect compensation
Press the C key on the PC.
Mode dial/battery adjustment
Press the M key on the PC.
DC jack adjustment
Press the D key on the PC.
Picture adjustment
Press the P key on the PC.
AF adjustment
Press the A key on the PC.
Flash adjustment
Press the S key on the PC.
End setting
Press the E key on the PC.
Firmware download
Press the F key on the PC.
Display adjustment results (1)
Press the F1 key on the PC.
Display adjustment results (2)
Press the F2 key on the PC.
