4.Adjustment and Check
FinePix6800Zoom(U/E/EG) SERVIS GUIDE
30
U
Fig.51
Fig.52
Fig.53
Fig.54
(note)
Since a USB device must be unique among individual units and be the only such device in the world, USB standards mandate
that a unique ID be given to each unit. Accordingly, if the main PWB assembly is replaced, the ID of the repair center must be
entered to grant a new unique device ID. The location of the repair centers are shown in the table below. (Writing this data to
the EEPROM is performed by the PC adjustment software. Follow its instructions.)
U_model
E/EG_model
Repair position
Repair position ID
Repair position
Repair position ID
America
61(A)
England
66(F)
Canada
62(B)
Germany
67(G)
Hawaii
63(C)
France
68(H)
Taiwan
64(D)
Spain
69(I)
Others
65(E)
Italy
6A(J)
Natherlands
6B(K)
Belgium
6C(L)
Sweden
6D(M)
Switerland
6E(N)
Norway
6F(O)
Finland
70(P)
Singapore
71(Q)
Others
72(R)
**Indicates ASCII code ( ) indicates decimal
notation
<< Repair position ID NO. >>
J: End Setting
Press J on your PC keyboard to select End setting from the adjustment menu. Within End setting, conduct Select the
destination, Choose repair position operations and the USB-ID Input, then conclude the program.
Pressing J on the adjustment menus screen will return you to the destination selection screen, so select your destination.
When destination selection is complete, the repair position selection will be confirmed. Press Enter to complete operation. (Fig. 52)
Press the Enter key to write the data that switches the camera from Jig mode to normal mode. The camera will not
operate in Jig mode once the power is off. (Fig. 53)
Press the Enter key.
Press the Enter key again to end adjustment.
Please pull out DC power supply of the camera. (Fig.54)
Conclude the operation by selecting [Operation] -> [End].
