安全に関する情報
– Safety Information
FRC-200S-1
Technical data
Maximum working pressure
6.3 bar / 90 psig / 0.63MPa
FRC-200S-1
Free speed (rpm)
4200
Power (W)
1000
Weight (kg)
6.3
Weight (lb)
13.6
Load air consumption (m³/min)
1.0
FRC-200S-1
Sound pressure level (dB(A))
83
Vibration (m/s²)
< 2.5
Vibration Uncertainty
----
Uncertainty 3 dB(A), in accordance with ISO 15744.
For Sound power level, add 11 dB(A).
Vibration standard : ISO 20643.
Declarations
Noise and vibration
Uncertainty 3 dB(A), in accordance with EN ISO
15744. For Sound power level, add 11 dB(A)
Vibration standard :
ISO 20643
These declared values were obtained by laboratory type
testing in accordance with the stated standards and are
suitable for comparison with the declared values of
other tools tested in accordance with the same standards.
These declared values are not adequate for use in risk
assessments and values measured in individual work
places may be higher. The actual exposure values and
risk of harm experienced by an individual user are
unique and depend upon the way the user works, the
workpiece and the workstation design, as well upon the
exposure time and the physical condition of the user.
We,
Fuji Industrial Technique Co., Ltd
, cannot be
held liable for the consequences of using the declared
values, instead of values reflecting the actual exposure,
in an individual risk assessment in a work place
situation over which we have no control.
This tool may cause hand-arm vibration syndrome if its
use is not adequately managed. An EU guide to
managing hand-arm vibration can be found by
accessing
and
selecting 'Tools' then 'Legislation'.
We recommend a program of health surveillance to
detect early symptoms which may relate to noise or
vibration exposure, so that management procedures can
be modified to help prevent future impairment.
If
this
equipment
is
intended
for
fixtured
applications:
The
noise
emission
is
given
as
a
guide
to
the
machine-builder.
Noise
and
vibration
emission
data
for
the
complete
machine
should
be
given
in
the
instruction
manual
for
the
machine
Safety
SAFETY is a primary consideration when using FRC-
200S-1. The machine should be used in the right way
with good understanding of how to use the tool safely.
Read and fully understand all the instructions before
use of the tool. If not, it might be dangerous to use the
tool. Keep this instruction manual for future reference.
Spindle and Cutter are rotating at high speed. Moving
parts can crush and cut. Keep hands away from
moving parts
Additional safety information is available from the
manufacturer or manufacturer’s agent in your country
when necessary.
Do not remove or allow to become obscured any labels
and/or markings shown on the tool.
Labels must be replaced immediately when damaged or
unreadable.
To reduce risk of injury, everyone using,
installing, repairing, maintaining, changing
accessories on, or working near this tool must
Summary of Contents for FRC-200S-1
