138
No.
Message
Action to Take
E-2635
E-2636
E-2637
E-2638
E-2639
E-2640
W-2641
W-2642
W-2643
W-2644
W-2645
W-2646
W-2660
E-2661
W-2679
I-2681
I-2682
Consult technical representative.
1. Check solution level. If it is normal,
consult technical representative.
2. If it is low, check that there is no solution
leak.
If there is leak, consult technical
representative.
3. If there is no solution leak, add water into
the low level tank.
4. Open the menu 465 “Evaporation
Correction Rate Setting” and make sure
“YES” is selected for “Evaporation
Correction”.
Replace the element with a new one.
Consult technical representative.
Remove prints from the sorter.
Wait.
Wait. Perform control strip processing after
paper processing.
P2 safety thermostat activated.
Heater turned off.
Call technical representative.
PS1 safety thermostat activated.
Heater turned off.
Call technical representative.
PS2 safety thermostat activated.
Heater turned off.
Call technical representative.
PS3 safety thermostat activated.
Heater turned off.
Call technical representative.
PS4 safety thermostat activated.
Heater turned off.
Call technical representative.
Safety thermostat in dryer section activated.
Heater turned off.
Call technical representative.
P1 solution level has fallen.
Temperature adjustment stopped.
Refer to manual for guidance.
P2 solution level has fallen.
Temperature adjustment stopped.
Refer to manual for guidance.
PS1 solution level has fallen.
Temperature adjustment stopped.
Refer to manual for guidance.
PS2 solution level has fallen.
Temperature adjustment stopped.
Refer to manual for guidance.
PS3 solution level has fallen.
Temperature adjustment stopped.
Refer to manual for guidance.
PS4 solution level has fallen.
Temperature adjustment stopped.
Refer to manual for guidance.
RC50D flow rate insufficient.
Replace element.
RC50D flow rate abnormal.
Call technical representative.
Sorter nearly full.
Collect prints from sorter.
Performing evaporation correction.
Please wait. (Max 50 min.)
After replenishment, start temperature
adjustment.
Processing paper.
Please wait.
Perform control strip processing after paper
processing.
Summary of Contents for FRONTIER 390
