70S+A_Rev1
104
Error Message List
Press ENT when an error is shown on the monitor. The [HELP] screen displays the following.
When an error is in the list below, the splicer repeats the alignment when the operator
presses the SET key.
・
L-Too Long Fiber
・
R-Too Long Fiber
・
LR-Too Long Fiber
・
L-Too Dusty Fiber
・
R-Too Dusty Fiber
・
ZL Motor Overrun (Forward)
・
ZR Motor Overrun (Forward)
・
ZL Motor Overrun (Backward)
・
X motor Overrun
・
Y Motor Overrun
・
Focus X Motor Overrun
・
Focus Y Motor Overrun
・
Cannot detect fiber in AUTO mode
・
L/R-Bad Fiber Position
When an error is in the list below, the splicer carries out operation which changes with preset
values of “Ignore Splicing Error”, when the operator presses the SET key.
See Section [Splice Settings].
・
Large Cleave Angle
・
Large Fiber Angle
・
Cleave Shape NG
・
Thin
・
Fat
・
Bubble
・
Dust Burned
・
High Loss Estimated
Follow the solution precisely as shown in the list below. If it is not possible to eliminate the
problem, the splicer may require service by a qualified service center. Consult the authorized
distributor with the following information:
・
Model name of the splicer
・
Serial number of the splicer
・
Error message
・
Situation when the error occurs