70S+A_Rev1
80
Heater Menu
Tube-heating for Splice-on-connector
This splicer can handle tube-heating for splicer-on-connector.
Fujikura Fuse Connect can be used by removing the right clamp of the heater and the heating
operation can be performed normally.
Remove heater clamp
Loosen the screw in the right side of the heater and remove the clamp. Use attached
screw driver (SD-01). Then, it enables to set the splice-on-connector with the connector
holder.
When using Fujikura Fuse Connect, where a clamp is removed, a connector holder is set
to heater right-hand side, and heating can be performed.
Please press down a connector holder from a top in the yellow direction of a line,
and attach a screw. Use attached screw driver (SD-01).
Tube-heating for Drop Cable
Use a carrying tool not to get the fiber twisted. if not using the tool, take care not to get the fiber
twisted. Set so that a cable becomes flat at a right-and-left clamp part.