70S_Rev1
7
General information
New function of 70S
Automatically wind-protector
Wind-protector at the time of splicer work is operated automatically.
The wind-protector operation after the end of work can be changed by choosing the mode
which wind-protector opens and closes.
New Heating system
If a protection sleeve is set, a lid will close automatically and it will start heating work.
Corresponds to connector splice
The connection of a field assembly optical connector by heating of a protection sleeve can be
performed by a 70S.
Moreover, versatility is improved by portability.
Corresponds to Short length splice
In addition to the standard splice, splice of 5-mm interference also recently became possible.
Cleaver Counter
The use situation of the optical fiber cleaver currently used for splice is displayed, and alarms,
such as change of a cutting position and change of edge quantity, are displayed by a splicer
on a plane. The large cleave angle and cleave shape NG at the time of fiber cutting,
aggravation of a splice loss, etc. can be prevented in advance.
The optical fiber cleaver currently used when an alarm screen is displayed is adjusted.
Using of work tray
The work tray can be used immediately when removed from the inside of a main part storage
carrying case can be used.
Moreover, the carrying case can be used as a working table.
Upgrade of software
The software of 70S is upgradable from on the Internet. Please install Data Connection in
attached CD manual.
A specialized tool is needed in order to perform 5-mm prepared.