70S_Rev1
74
Maintenance
Clear Cleaver Counter
This function was the stored number of [Cleaver Counter] to be reset.
1. Select the [Clear Cleaver Counter].
2. As the confirmation screen “Is it OK to clear?” appears, press ENT key to clear.
It performs, after adjusting Cleaver who is using it.
Motor Drive
The two motors incorporated in the splicer can be manually operated individually. In the
course of splicing, the motors can also be operated by calling this menu in the [PAUSE], or
[FINISH] state.
1. Select the [Motor Drive].
2. Pressing MENU key changes motor selection. The name of the selected motor is
displayed in the upper section of the screen.
3. Press Up/Down Arrow key to drive the motor in the desired direction.
Motor
Up Arrow key
Down Arrow key
ZL/ZR
Forward
Backward
X/Y
Upward.
Downward.
Focus X/Y
Lens moves
nearer fiber.
Lens moves away
from fiber.
Parameter
Descriptions
Cleave Count
The number of times of cleave is
displayed.
Blade Position
The position of a blade is displayed.
Blade Height
The height of a blade is displayed.
When the motor reaches the limit of the operating range, the buzzer sounds and the
motor stops. Press the opposite arrow key to reverse and move the motor again.
Display messages can be erased by pressing ENT key. The message can be
displayed by pressing ENT key again.
If the motor is moved too much with respect to the spliced fiber, the fiber may break.