70S_Rev1
82
Error Message List
Press ENT when an error is shown on the monitor. The [HELP] screen displays the following:
・
If error does not have an error code, such as “Cleave Shape NG”, the keystrokes are
displayed with information explaining what each keystroke does if pressed.
・
If error has an error code, additional information according to the Error Code and Message
is displayed.
Follow the solution precisely as shown in the list below. If it is not possible to eliminate the
problem, the splicer may require service by a qualified service center. Consult the authorized
distributor with the following information:
・
Model name of the splicer
・
Serial number of the splicer
・
Error message
・
Error code (if shown)
・
Situation when the error occurs
Error
Message
Reason
Solution
L-Too Long
Fiber
・
The cleave length (bare
fiber part) is too long.
・
Dust or dirt is on the
objective lens or the
wind-protector mirror.
・
Confirm the setting position of the stripped fiber
end on the fiber cleaver. Check the cleave
length.
・
Execute the [Dust Check]. Clean the lens or the
mirror when dust or dirt exists.
R-Too Long
Fiber
LR-Too Long
Fiber
X-Dark
Back Ground
・
Dust or dirt is on the
objective lens or the
wind-protector mirror.
・
Execute the [Dust Check]. Clean the lens or the
mirror if dust or dirt exists.
Y-Dark
Back Ground
X-Dark
Back Ground
・
The LED or Camera
might be damaged.
・
Consult the authorized distributor.
Y-Dark
Back Ground
L-Too Dusty
Fiber
•
Dust or dirt is on the fiber
surface.
•
Dust or dirt is on the
objective lens.
•
[Cleaning Arc] time is too
short or “OFF.”
•
Completely prepare the fiber again (strip, clean
and cleave).
•
Execute the [Dust Check]. Clean the lens if dust
or dirt exists.
•
Set the [Cleaning Arc] time to “150ms.” When
splicing carbon coated fibers, set to “200ms.”
R-Too Dusty
Fiber