70S_Rev1
91
Questions and Troubleshooting
Tube-heating Operation
(1)
Fiber protection sleeve does not shrink completely
・
Extend the heating time. Refer to [Heater Mode].
(2)
Heater LED on panel keyboard blinks
・
Pressing the HEAT key during heating causes the LED to blink. The tube heater is turned
off if the HEAT key is pressed again. If, after 2 seconds have gone by without pressing the
HEAT key again, the LED stays on continuously and the heater returns to its normal state.
The LED will turn off when the heat cycle is completed.
・
If the heating temperature does not reach its inputted setting, the LED blinks and the alarm
sounds. If this happens, contact the authorized distributor.
(3)
Fiber protection sleeve adhered to heating plate after shrink
・
Use a cotton swab or a similar soft tip object to push and remove the sleeve. If the black
coating is removed, contact your authorized distributor.
(4)
Method to initialize heating condition of Heater mode
・
See Section [Referring to or editing Heater Mode].
(5)
Method to cancel heating process
・
RESET key does not cancel the heater. Press HEAT key twice to cancel the heating
process.
Supervising
(1)
What functions can be disabled
・
See Section [Menu Lock Settings].
(2)
Method to lock “selection” or “editing” of Splice or Heater mode
・
See Section [Menu Lock Settings ].
(3)
Method to set parameters of Splice or Heater mode from a PC
・
Refer to the communication software “Data Connection” included in CD-ROM.
(4)
Forgot password
・
Contact the authorized distributor.