10
Installation
3. Attaching Exhaust Port
(Discharge Type)
Note
When connecting the exhaust port using drilling tapping
screw, be careful not to touch to the shatter. Fix it within
the usable range referring to the fig.
Taping duct joint (Discharge Type)
Make the duct joint secure and air-tight using non-
flammable tape such as duct tape, etc. (not supplied)
45mm
or more
15mm
or more
Shatter axis
Drilling tapping screw
Exhaust port
Drilling tapping screw
usable range
Exhaust duct
Duct tape
3) Removing oil tray
Push the front of the oil tray. As the oil tray comes
out a little, pull it out slowly by holding both sides.
Cover
Fixing screw
4) Opening cover
Remove 2 screws fixing the cover, and swing
open it as shown.
5) Fixing enclosure
Fix the rear of the enclosure firmly using
supplied 2 washer-head wood screws.
Push
6) Close the cover and fix it with
2 screws, then replace the oil
tray in position.