11
Installation
2mm
Fixing screw
3
Fixing duct cover
1) Inser t supplied 4 screws on the top of the
enclosure as shown. Be sure to keep about 2mm
space between the top and screw-head.
2) Put the duct cover with aligning its 4 bottom
cutouts with the screws, slide it backward, then
tighten 4 screws securely.
Fixing screw
Fixing screw
Duct cover
Duct cover
front panel
Top plate
Duct cover
fixing bracket
Roller catch
Duct co
ver height
(Standard:
530)
30
Exhaust duct
A
B
C
Wood
screw
Washer
Duct cover fixing bracket
1
Disassembling duct cover
Remove the front panel and duct cover fixing bracket
from the duct cover supplied.
Note
In case of upper discharge, remove the top plate also.
2
Fastening duct cover fixing bracket
According to the height of the duct cover, fasten the
duct cover fixing bracket on the wall using supplied
2 washers and wood screws.
Note
Use fixing hole A, C for backward discharge, and B,
C for upward discharge.
4. Attaching Duct Cover
(Discharge Type)
Duct cover
front panel
Duct cover
Roller catch
Fixing screw
Wood screw
4
Attaching front panel
Replace the front panel with engaging its top
notches first, then pushing its bottom to set
into the roller catch.
3) Fix the upper left and right sides of the duct cover
to the duct cover fixing bracket with 2 screws.
4) Tighten 2 wood screws for the duct cover fixing
bracket firmly.