22
Caution f
or Maintenance
• Before cleaning the cooker hood, be sure to
disconnect the power plug from the receptacle, or
turn off the breaker.
• For safety, always wear a pair of rubber gloves while
cleaning the disk, etc.
• Especially, be careful to prevent electric parts such
as the motor, switch, connectors or the like from
being splashed with water.
• Do not spray liquid of any type detergent to the
electric parts. It’s cause trouble.
• Do not use solvents such as thinner, benzine,
polishing powder or the like for cleaning the painted
surfaces, facing plates, etc. as these parts may
become lusterless or scored.
• Do not wash parts with a hard brush or the like for
cleaning as it can be damaging.
• If you do not clean the cooker hood according to the
methods stipulated in the operation manual, it may
lead to a fire hazard.
It is very easy to stain the cooker hood, therefore, be sure to frequently clean the cooker hood (especially for the disk,
it should be cleaned for one at least 2 months. For the family cooking two meals, be sure to clean the disk for once at
least one month).
If cooker hood is not cleaned for a long time, a lot of greasy dirt accumulates to form stubborn greasy hard lump.
If oil tray, surroundings of the cooker hood and rectifier panel are polluted, please timely clean it every time. (Cleaning
standard: once about 2 months)
Install all parts using the opposite procedure as that for removing the parts.
Caution for Maintenance
Hooking bracket
Open
Hanging
bracket
Loose
Braking buckle
Make it
sliding
Fixing
clip
Press lock device
Rectifier
panel
Raise up
a little
Removal of the rectifier panel
1) Loosen the 2 bolts of the fixed braking buckle till the
braking buckle can slide back and forth (
).
2) Use your hands to support the rectifier panel, slightly
push upward to press the hooking bracket on left and
right sides of the rectifier panel for removal (
).
3) Use your hands to support the rectifier panel and at the
same time, slowly dismantle it (
).
4) Lift the rear end of the rectifier panel according to the
position as shown in the lower right figure to dismantle
it from the hanging bracket of the cooker hood (
).
* Please be sure to dismantle the left and right one at
the same time. Otherwise, it causes the deformation
of metal parts.
Detaching Cleaned Parts
Caution Matters for Maintenance
Note
There may exist oil accumulation on the rectifier panel during
dismantling process, please note the dripping of oil.
When rectifier panel is cleaned, note to keep the hooking
bracket, magnet installation portion and hanging metal parts
free from deformation.
If there exists deformation, it causes the failure of secondary
installation of the rectifier panel.
Please do not dismantle the magnet on the rectifier panel.
And furthermore, do not close to other magnet and magnetic
substance.
Magnet installation portion
Hooking bracket
Hanging metal parts
