25
Caution f
or Maintenance
Oil tray
(If any greasy dirt is found, please immediately clean it. Standard: about once every
2 months)
Soak it into the warm water containing neutral detergent and clean it with soft sponge, etc.
After cleaning greasy dirt, in order to avoid the residual of detergent, wash it by water and
carefully wipe it before installation.
* The greasy dirt is accumulated in the oil tray, and the accumulating stock varies from the
service condition. Although the amount is small, it is normal.
Note
Please do not put the oil tray in dishes washing drier. Maybe, it causes coating shedding due to coating aging.
* Metal brush, scrubbing brush and other hard object will cause scratching on the clean surface, so, please do not use it.
* If alkaline detergent is used, maybe, it causes surface color change.
Disk
(If any greasy dirt is found, please immediately clean it. Standard: about once every
2 months)
Soak the disk in water in advance and wash it along with the meshes of the disk with
soft sponge, etc.
When there is too much greasy dirt, please clean it with neutral detergent.
If the blocked mesh is ignored, it causes poor ventilation and abnormal sound/vibration.
Note
Fully wipe the water in the insertion portion of the motor shaft while
cleaning to dry it, and then, carry out installation.
Please do not wipe the lubricating oil on the motor shaft. The lubricating
oil prevents motor shaft from rusting.
The neutral
detergent
Coating parts of
lubricating oil
Motor shaft
Don't wipe
the grease off
The neutral
detergent
Rectifier panel
(If any greasy dirt is found, please immediately clean it.)
In order to avoid the residual of detergent, wipe it out with wet cloth carefully after wiping
it with the soft sponge/soft cloth soaked into the warm water of neutral detergent.
Note
Sometimes, there is serious accumulation of greasy dirt, at this time, soak rectifier panel into the warm water
containing neutral detergent, wipe out the greasy dirt when it becomes loose.
Please be sure to dismantle the rectifier panel from the main body of the cooker hood before cleaning. Otherwise, it
causes falling off/deformation.
Please put the dismantled rectifier panel horizontally for cleaning. Otherwise, it causes deformation/scratching.
When rectifier panel is used, please do not bump against or dismantle the magnet. It may cause the failure of the
automatic operation shutdown.
* Metal brush, scrubbing brush and other hard object will cause scratching on the clean surface, so, please do not use it.
* If alkaline detergent is used, maybe, it causes surface color change.
The neutral
detergent
Magnet
Cooker hood and Oil panel
(If any greasy dirt is found, please immediately clean it.)
In order to avoid the residual of detergent, wipe it out with wet cloth carefully after
wiping it with the soft sponge/soft cloth soaked into the warm water of neutral detergent.
Especially, the greasy dirt at the lower end of the cooker hood is adhered easily, please
wipe it out carefully.
Note
* Metal brush, scrubbing brush and other hard object will cause scratching on the clean
surface, so, please do not use it.
* If alkaline detergent is used, maybe, it causes surface color change.
The neutral
detergent
Cleaning
