14
Maintenance
4
Attaching oil tray
Install the supplied oil tray on the rectifier panel. Align the 2
projections of the supplied oil tray with the installation hooks
of the rectifier panel. Insert the projections, slide the tray
backwards and secure it.
Hook
➀
Close
➁
Hanging bracket
Hooking bracket
Make sure it is
firmly locked.
3
Attaching rectifier panel
1) Securely hang the left and right hooking bracket at the rear of the rectifier panel on the hanging
bracket (
①
) of the cooker hood.
2) Support the rectifier panel with both hands and lift the front end upwards until a “snap” sound
is heard, and it is secure (
②
).
After installing, pull the rectifier panel up and down to make sure it will not drop.
Note
In order to prevent fasteners falling due to insufficient locking, please
make sure that the rectifier panel is locked securely.
Maintenance
Operation checking
Turn off the circuit breaker on the distribution board, and then plug the power plug into the outlet.
After turning on the circuit breaker, switch on the hood to check the operation. Refer to page 6 for
instructions on switch operation and operation state confirmation.
Check if the fan rotates normally at all speeds during operation.
Check that there are no abnormal noise or vibration.
Clean the cooker hood frequently as it will become greasy (especially, clean the filter at least once a
month. For a family, cooking at least twice a day, clean the filter once in every two weeks).
If the cooker hood is left unattended for a long time, a large amount of oil will accumulate and become
hardened grease, which is difficult to remove.
Always clean the oil tray, external body and the rectifier panel in a timely manner (cleaning frequency:
about once a month).
Installation
