P2
If the supply cord is damaged, it must be replaced by the
manufacturer, its Service agent or similarly qualified persons in
order to avoid a hazard.
There shall be adequate ventilation of the room when the
cooker hood is used at the same time as appliances burning
gas or other fuels (not applicable to appliances that only
dis-charge the air back into he room);
There is a fire risk if cleaning is not carried out in according with
the instructions.
Do not flambe under the cooker hood.
The cooker hood is intended to be installed over a hob with up
to four hob elements or burners.
Vent System Requirements
Determine
which
venting
method
is
best
for
your
application.
Vented
system
must
be
terminate
d
to
the
outside.
Ductwork
can
extend
either
through
the
wall
or
the
roof.
Do
not
terminate
the
vent
system
in
an
attic
or
other
en-closed
area.
The exhaust duct should be as short as possible, generally not
longer than 1.5m.The radius if any bends in the pipe should be
as large as possible.The size of the ductwork should be uniform.
Do not install two elbows together. Use duct tape to seal all
joints in the ductwork system. Use caulking to seal exterior wall
or floor opening around the cap.
Make sure there is proper clearance within the wall or floor for
exhaust duct before making cutouts. Do not cut a joist or stud
unless absolutely necessary. If a joist or stud must be cut, then
a supporting frame must be constructed.
Summary of Contents for FR-HS1870
