15
Attaching
Rectifier Panel
Detaching
Hold the rectifier panel with two hands on both sides,
slightly pull it out to loosen the front end,then turn down
the rectifier panel to take it out of the cooker hood.
Note
Make sure that the rectifier panel is fixed securely.
It may be a cause of dropping if not fixed firmly.
Note
In order not to drop the rectifier panel, hold it by both
hands securely. If dropped, it may be a cause of injury,
flaw or warp of parts, etc.
Hold the rectifier panel with both hands, hang the end
of it into the hooking bracket,align the front end with the clamp
anchor and push it to the end,and ensure that the
rectifier panel is fully clamped in the ball catch.
Install all parts using the opposite procedure as that for removing the parts.
Oil Tray
Detaching/Attaching Cleaned Parts
Note
The oil tray may be filled with oil, so be careful when removing it.
When removing the oil tray,be sure to hold
the rectifier panel by hand to avoid accidental falling
o
ff
and causing injury.
Note
If the oil tray is not installed properly, it may result in oil dripping,
injury by dropping, etc.
Attaching
Hold the oil tray,insert the oil tray foot into the oil tray
hole,then push it completely to the end.
Detaching
Hold the rectifier panel with the le
�
hand,hold and pull
the oil tray with the right hand(first pull one side of the oil
tray out of the clamp,then pull the other side out of the
clamp in accordance to the convenience.)
Maint
enanc
e
Hooking Bracket
Ball Catch
Rectifier panel
