11
Installation
Assembly
2
Attaching rectifier panel
Holding the rectifier panel with both hands,
place the rear of the panel in front of the
catches and in line with the mounting
guide holes. Then slide the panel back to
engage the mounting guides and attach
the catches.
Tighten the mounting screw to attach the
panel firmly.
Note
Make sure that the rectifier panel is fixed
securely. It may be a cause of dropping
if not fixed firmly.
Note
In case of backward discharge,
re-assemble the top plate.
Catch
Mounting guide hole
Mounting screw
Rectifier panel
1
Stripping off the fixing tape
Strip off the oil tray fixing tape.
Fixing tape
Oil tray
4
Attaching front panel
Replace the front panel with engaging its
top notches first, then pushing its bottom to
set into the roller catch.
Front panel
3
Attaching oil receiving cover
Holding the oil receiving cover with one
hand at each end, align the slits on the
bottom panel of the body with the slits on
the cover. Swivel the top part of the cover
up and to the body in the direction shown
by the arrow. Make sure that the catches
at both ends of the oil receiving cover are
firmly latched.
Catch
Oil receiving cover