Fujitsu Siemens Computers 383V FA, Operating Manual

Colour monitor 383V FA

10 - English

A26361-K873-Z100-2-5E19

i

If your computer has a power management function (energy-saving mode), you should
read the "Notes on power management" of the monitor in this chapter.

Notes on power management

If your computer is equipped with power management, the monitor can support this function fully.
Here the monitor does not distinguish between the individual energy-saving modes of the computer
(standby mode, suspend mode and OFF mode), as it is capable of immediately switching into the
mode with the highest energy-saving effect.

Stage

ON

Energy-saving mode

Power indicator

lights green

glows amber

Function

Monitor operating

normally

Monitor

is dark

Power consumption

normal

< 35 W

reduced to < 3 W

If your computer detects inactivity (no input) it sends an appropriate signal to the monitor to reduce
the power consumption (energy-saving mode). The power indicator of the monitor changes colour to
indicate the status change.

Once an input is made at the computer the screen contents are redrawn and full power is restored.

For detailed information on how energy-saving mode operates refer to the Operating Manual or
Technical Manual of the computer.

i

When the monitor is switched to the energy-saving mode by the power management
system a power consumption of up to 3 W is maintained to feed the circuit for redrawing
the screen contents.

To completely switch off the power consumption, switch off the monitor or the computer.

Changing the monitor settings

When putting the monitor into operation for the first time, the screen display should be optimally
adapted to the screen controller used and adjusted in accordance with your needs.

Basic monitor settings with the floppy disk supplied

If one of the operating systems Windows for Workgroups, Windows 95/98, Windows NT,
Windows Me, Windows 2000 or OS/2 (with Windows emulation installed) is used, the basic monitor
settings can be set with the floppy disk supplied.

Ê

Insert the supplied floppy disk into the floppy disk drive.

Ê

Open the 

Readme

 file on the floppy disk and follow the instructions in the file.

Your monitor should now already be properly adjusted. If none of the above operating systems is
used or minor corrections are to be made to the screen display, then change the monitor settings
with the OSD menu.